6 rx interface (menu) -10 – Comtech EF Data MM200 User Manual
Page 34

User Interfaces
MM200 High-Speed Microwave Modem
4-10
TM086 - Rev. 4.1
CLK POLARITY
DATA INVERT
BB LOOP
VOLUME
PIDs on a framed interface.
Note: Only appears when using DVB
Framed Interfaces such as L0I.
{Normal, Inverted}
Sets the polarity of the clock.
Note: Only appears when supported
by the installed interface.
{Normal, Inverted}
Sets the polarity of the data.
Note: Only appears when supported
by the installed interface.
{Normal, Inverted}
Baseband Loopback. Not yet
implemented, for future expansion.
{0 - 255}
Allows the user to set volume level
(Orderwire only).
Note: Only appears when supported
by the installed interface.
RW
RW
RW
RW
TX INTRFC2 (menu)
Transmit Interface 2. Refer to TX
INTRFC1 (menu) for descriptions.
TX INTRFC3 (menu)
Transmit Interface 3. Refer to TX
INTRFC1 (menu) for descriptions.
TX INTRFC4 (menu)
Transmit Interface 4. Refer to TX
INTRFC1 (menu) for descriptions.
4.3.6 RX INTERFACE (Menu)
The primary Rx Interface Screens and their sub-menus as listed below:
Screen Name
Selections and Descriptions
L2
RX INTRFC1
CONTROL
DATA RATE (BPS)
INTERFACE
FRAMING
Receive Interface 1
{Disable, Enable}
Enables or disables the installed interface.
Dependant upon interface type. For
variable interfaces, this unit must be set
by the user. Will not show up on fixed
rate interfaces.
Dependant upon interface type. Selects
the interface standard for multiple
standard interface card, or displays
standard for fixed interfaces.
{Unframed, MPEG188, MPEG204}
Used for DVB Interface framing selection.
Shows only in DVB Framed Interfaces.
RW
RW
RW
RW