Comtech EF Data MM200 - Manual (Page 102)

Appendix A MM200 High-Speed Microwave Modem
A-2 TM086 – Rev. 4.1
configuration
Query Mod Tx Enable 0x2054 Returns the carrier enable status
Query Mod Tx Carrier 0x2055 Returns the carrier mode
Query Mod Channel Status 0x2070 Query selected modulator channel status
Query Mod Channel Configuration 0x2071 Query selected modulator channel
configuration
Query Mod Channel Config & Status 0x2072 Query selected mod channel config and status
Query Mod Status 0x207D Query modulator status
Query Mod Configuration 0x207E Query modulator configuration
Query Mod Configuration & Status 0x207F Query modulator configuration and status
Query Demod Diversity Status 0x2098 Query demodulator diversity status
Query Demod Channel Status 0x20B0 Query selected demodulator channel status
Query Demod Channel Configuration 0x20B1 Query selected demod channel configuration
Query Demod Channel Config &
Status
0x20B2 Query selected demod channel config and
status
Query Demod Status 0x20BD Query demodulator status
Query Demod Configuration 0x20BE Query demodulator configuration
Query Demod Configuration & Status 0x20BF Query demodulator configuration and status
Query Tx Interface Status 0x2140 Query selected Tx interface status
Query Tx Interface Configuration 0x2141 Query selected Tx interface configuration
Query Tx Interface Config & Status 0x2142 Query selected Tx interface config and status
Query Tx Interface Jitter Control 0x2143 Query selected Tx interface jitter control
Query Rx Interface Status 0x2160 Query selected Rx interface status
Query Rx Interface Configuration 0x2161 Query selected Rx interface configuration
Query Rx Interface Config & Status 0x2162 Query selected Rx interface config and status
Query Rx Interface Jitter Control 0x2163 Query selected Rx interface jitter control
Query Rx Interface Byte Gapping 0x2164 Query selected Rx interface byte gap
Command Control Mode 0x2201 Set control mode
Command Time 0x2204 Set time
Command Date 0x2205 Set date
Command Time and Date 0x2206 Set time and date
Command Clear Latched Alarms 0x2207 Clear latched alarms
Command Common Alarm Mask 0x2208 Set common alarm mask
Command Last Rate Control 0x2209 Set last rate control
Command Frequency Plan 0x220A Set IF frequency plan
Command User Mode 0x220B Selects the user mode
Command Mux Loopback 0x220C Selects the multiplexer loopback mode