Monitoring/fault – ATEIS IDA8C User Manual

Page 68

Ateis Studio

The meaning of parameters list below:

Amount

Specify the number of backup amplifiers in system. the list content of combo box in amplifier

depends on this value. For example, if Amount = 3, then the list content should be none, 1, 2, 3.

Field [Device] of Grid

List devices within the same Ateis Net.

Field [Zone Board] of Grid

List zone boards of the device. zone board1 means zone1 to zone4, zone board2 means zone5

to zone8.

Field [Amplifier] of Grid

Specify the group no of zones. In the above figure, IDA8S1 zone board1(zone1~zone4 of

IDA8S1), IDA8S2 zone board1(zone1~4 of IDA8S2), IDA8S2 zone board2(zone 5~8 of IDA8S2)

are the same value, i.e. those zones are the same group and use the same amplifier for backup.

4.1.6 Monitoring/Fault

For the security purpose, IDA8 is designed to monitor the equipment, when a error detected, a fault will

be generated to inform user, then user can change the failure equipment quickly to make system

working fine again.

There are two type of faults:

System Fault

This kind of fault is about the internal error of IDA8C/S and most of case is hardware failure, it need

to change board inside device to repair.

Global Fault

A global fault is mostly speak about the fault of equipment outside IDA8C/S.

This manual is related to the following products: