ATEIS IDA8C - Manual (Page 110)

Ateis Studio 110
© 2012 ATEÏS
Use Evacuation Input component
By use Evacuation Input component, you can control the other logic components. Logic signal is
coming from Evacuation Input component and goes any other input pins of logic component as
you want. please refer to topic Evacuation Input component.
They also can be used in UGA mode, trigger by a voltage polarization change. To setting this option you
need use Evacuation Input component, please refer to topic Evacuation Input component.
4.1.8.2 Contact Output
In the IDA8C/S devices, there are logic outputs channels to close/open circuit for an external device.
There are two ways to config it:
Assign element to evacuation output control