ATEIS IDA8C - Manual (Page 106)

Ateis Studio 106
© 2012 ATEÏS
4.1.6.7 Global Settings
There are global settings listed below:
Enable Monitor
A check box to determine enable or disable monitor function.
Enable Leakage
A check box to determine enable or disable leakage detect function.
Leakage Threshold(1k ohm)
A threshold value for leakage detection. If leakage impedance lower than this value, the fault
Leakage Occurrence is detected.
Leakage Calibration
If system detect a leakage fault, but the circuit does really not have this problem after doing some
propriety check, it need to do a leakage calibration to make monitor function working fine.