ATEIS IDA8C - Manual (Page 183)

Product Features 183
© 2012 ATEÏS
Status Frequency Activity
Permanent There are faults in audio processor.
Blinking ° ° Lost communication with audio processor.
5. EVAC Indicator
Light up when the system is under evacuation paging.
6. Power Indicator
This LED light up when the CD8 is powered on.
7. Monitoring Speaker
This embedded speaker to play chime when paging or monitor signal from audio processor, it needs
to work with rs485 output component to get audio signal from other DSP components in audio
processor.
8. Fireman Microphone Connector
DIN Connector for fireman microphone connection.
9. Music Input Connector
There are two music input channels of CDPA. Users can select one of them by pressing music
selection button.
10.Talk Indicator
This LED light up if PCP is allowed to paging, on the other word, the paging request has been
acknowledged.
Sometime after paging request is granted, zones under paging still can be occupied by other
sources. In such a case, the talk led still light up, but you can check busy LED to know the
situation.
11.Talk Button
Press this button to request paging. There are two modes for this button: push to talk and lock.
12. All Call/Release Button
This button is used to select or deselect all keys.
13.All Call/Release Indicator
This indicator lights up if all keys are selected.
14.Busy Indicator(1~8)
Show the status of zone:
Color Status Frequency Activity
Red Permanent Priority of the zone is lower than other sources.
Green Blinking ° ° Priority of the zone is higher than other sources.
Green Permanent
The zone only desired for paging is not using by other
sources.
15.Hold Indicator(1~8)