ATEIS IDA8C - Manual (Page 422)

Ateis Studio 422
© 2012 ATEÏS
Description
The job of Network Paging component is to route input source signal to zones using priority
arbitration. The pins on left side represents the paging sources, and the pins on right are zone. Pins
on top side are able to controls paging activity, and pins on bottom output logic signals to tell the
status of paging activity. Each source can specify which zones want to paging. when a source is
request for paging, not always get success, because the zones required maybe already occupied by
another source.
Network Cascading Paging
Some application like station PA system, requires a huge number of zones for paging. It need to
have multiple Ateis audio processor connected together using Ateis Net, and for each DSP
configuration of audio processor, there is a Network Paging component in charge of paging tasks.
The following figure is an example to show that:
Double click the Network Paging component open the settings window, the following sections describe
for parameters for each tab
Source Type