ATEIS IDA8C - Manual (Page 177)

Product Features 177
© 2012 ATEÏS
Color Status Frequency Activity
Red Permanent Priority of the zone is lower than other sources.
Green Blinking ° ° Priority of the zone is higher than other sources.
Green Permanent
The zone only desired for paging is not using by other
sources.
3. Fault Indicator
To display fault status of system. Following table list the states of fault:
Status Frequency Activity
Permanent There are faults in audio processor.
Blinking ° ° Lost communication with audio processor.
4. Monitoring Speaker
This embedded speaker to play chime when paging or monitor signal from audio processor, it needs
to work with rs485 output component to get audio signal from other DSP components in audio
processor.
5. Fireman Microphone Connector
DIN Connector for fireman microphone connection.
6. Talk Indicator
This LED light up if PCP is allowed to paging, on the other word, the paging request has been
acknowledged.
Sometime after paging request is granted, zones under paging still can be occupied by other
sources. In such a case, the talk led still light up, but you can check busy LED to know the
situation.
7. LED Test Button
Test LED on control panel, after pressing this button all LEDs light up and then off.
8. Hold Indicator(1~8)
These LEDs Indicate which keys are selected.
9. All Call Release Button
This button is used to select or deselect all keys.
10.All Call Release Indicator
This indicator lights up if all keys are selected.
11.Event Select Key(1~8)
These buttons are used to select keys, each key may link to an event for triggering actions like
paging or adjust the value of parameters.
12.Busy Indicator(9~16)
Please refer to Busy Indicator(1~8).
13.Hold Indicator(9~16)