AMETEK i-iX Series II User Manual
Page 66

User Manual
California Instruments
66
i Series II / iX Series II / iM Series II
The following top-level menu choices can be accessed from the MENU key:
Entry
Description
MENU 1
PROGRAM
The PROGRAM menu allows output parameters the be
changed.
MEASUREMENTS
The MEASUREMENTS screens are not menus in that no user
entries are required.
TRANSIENTS
The TRANSIENTS menu allows output transients to be
programmed. (i and iX Series only)
WAVEFORMS
The WAVEFORMS menu allows different waveforms to be
selected from the waveform library. (iX Series only)
MORE
The MORE selection causes the second part of the MENU
screen to be displayed. (MENU 2)
MENU 2
ADVANCED MEAS.
The ADVANCED MEAS. screens are for display only. No user
entries are required. (iX Series only)
APPLICATIONS
The APPLICATIONS menu provides access to the optional
firmware application programs that may be installed in the i/iX
Series AC source.
SETUP REGISTERS
The SETUP REGISTERS menu allows complete instrument
settings and transient list programs to be saved to nonvolatile
memory.
MORE
The MORE selection causes the third part of the MENU screen
to be displayed. (MENU 3)
MENU 3
UTILITY
The UTILITY menu provides access to less commonly used
setup screens such as those for the GPIB and RS232C (also
applies to USB and LAN) interface settings, initial startup
values, etc.
OUTPUT IMPEDANCE
The OUTPUT IMPEDANCE menu provides control of the AC
source output impedance. (Available only on 3001iX, 5001iX,
9003iX and 15003iX models. On systems with –MODE-iX
option, only available when in 3 phase mode.)
MEASUREMENT CAL
The MEASUREMENT CAL menu allows for calibration of the
AC source measurement system.
OUTPUT CAL
The OUTPUT CAL menu allows for calibration of the AC source
output.
Following the Menu overview pages is a detailed description of each menu and sub menu.