AMETEK i-iX Series II User Manual
Page 24

User Manual
California Instruments
24
i Series II / iX Series II / iM Series II
Parameter
Range
Accuracy (
±
)
Resolution
Accuracy specifications apply above 100 counts. Current and Power Accuracy specifications are times two for
10001iX and times three for 15001iX. For 10001iX and 15001iX, resolution decreases by factor of 10, ranges for
current and power increases by factor of three.
2.1.5 Harmonic Measurements (iX series)
Parameter
Range
Accuracy (
±
)
Resolution
Frequency fundamental
16.00 - 1000 Hz
2 counts
0.01 Hz to 1 Hz
Frequency harmonics
32.00 Hz - 16 kHz
2
°
typ.
0.5
°
Voltage
Fundamental
0.25V
0.01V
Harmonic 2 - 50
0.25V + 0.1% + 0.1%/kHz
0.01V
Current
Fundamental
0.05A
0.01A
Harmonic 2 - 50
0.05A + 0.1% + 0.1%/kHz
0.01A
Accuracy specifications are times three for three phase mode. Harmonics frequency range in three-phase mode is 32
Hz - 16 kHz. Resolution decreases by factor of 10 for 10001iX and 15001iX.
2.1.6 System Specification
Parameter
Specification
External Modulation: 0 to 10%
Synchronization
Input:
Isolated TTL input for external frequency control. Requires 5V at 5 ma
for logic high.
Trigger Output:
400
µ
s pulse for voltage or frequency change. Isolated output that
requires a pull-up resistor, 22K
Ω
, to + 5 VDC.
Non volatile memory
storage:
16 complete instrument setups and transient lists, 100 events per list.
Waveforms
Sine (i series)
Sine, square, clipped, user defined (iX series)
Transients
Voltage: drop, step, sag, surge, sweep
(i/iX only)
Frequency: step, sag, surge, sweep
Voltage and Frequency: step, sweep
IEEE-488 Interface:
SH1, AH1, T6, L3, SR1, RL2, DC1, DT1
IEEE 488.2 and SCPI
Response time is 10 ms (typical)
RS232C Interface:
Bi-directional serial interface
9 pin D-shell connector
Handshake: CTS, RTS
Data bits: 7, 8
Stop bits: 1,2
Baud rate: 9600, 19200, 38400 (Models without USB I/F)
Baud rate: 9600, 19200, 38400, 57600, 115200, 230400, 460800
IEEE 488.2 and SCPI.