AMETEK i-iX Series II - Manual (Page 23)

User Manual California Instruments
i Series II / iX Series II / iM Series II 23
Output Parameter i / iM Series iX Series
Output Noise:
(20 kHz to 1 MHz) <250 mV rms (typ),
<500 mV rms (max)
<250 mV rms (typ),
<500 mV rms (max)
Peak Rep AC Current:
3001i/iX
5001i/iX
9003i/iX
15003i/iX
110 A for 150 V range,
92 A for 300 V range 110 A for 150V range,
92 A for 300 V range,
10001i/iX 220 A for 150 V range,
184 A for 300 V range 220 A for 150 V range,
184 A for 300 V range
15001i/iX 330 A for 150 V range,
276 A for 300 V range 330 A for 150 V range,
276 A for 300 V range
Crest Factor: Up to 5:1 Up to 5:1
2.1.3 AC Measurements
Note: Measurements are not available on iM Series II models.
Parameter Range Accuracy (
±
) Resolution
Frequency 16.00 - 1000 Hz 2 counts 0.01: 16 to 81.91 Hz
0.1: 82.0 to 819.0 Hz
1: 820 to 1000 Hz
RMS Voltage 0 - 300 Volts 0.25V + 0.1%, <100 Hz
0.25V + 0.2%, 100-1000 Hz 0.01 Volt
RMS Current 0 - 40 Amps 0.25A + 0.1%, <100 Hz
0.25A + 0.2%, 100-1000 Hz 0.001 Amp
Peak Current 0 - 119 Amps 0.5A + 0.2%, <100 Hz
0.5A + 0.5%, 100-1000 Hz 0.01 Amp
VA Power 0 – 6000 VA 10 VA + 0.1%, <100 Hz
20 VA + 0.2%, 100-1000 Hz 1 VA
Real Power 0 – 6000 W 10 W + 0.1%, <100 Hz
20 W + 0.2%, 100-1000 Hz 1 W
Power Factor
(>0.2kVA) 0 - 1.00 0.01
Accuracy specifications apply above 100 counts. Current and Power Accuracy specifications are times two for
10001iX and times three for 15001iX. For 10001iX and 15001iX, resolution decreases by factor of 10, ranges for
current and power increases by factor of three. Measurement bandwidth is limited to 16 Khz.
2.1.4 DC Measurements
Note: Measurements are not available on iM Series II models.
Parameter Range Accuracy (
±
) Resolution
Voltage 0 – 400 Volts 0.4 Volts 0.01 Volt
Current 0 – 40 Amps 0.1 Amps 0.001 Amp
Power 0 – 6000 W 20 W 1 W