beautypg.com

AMETEK i-iX Series II User Manual

Page 28

background image

User Manual

California Instruments

28

i Series II / iX Series II / iM Series II

2.6 Special Features, Options and Accessories

Feature

Description

Programmable
Impedance.

Output impedance programming available on models 3001iX,
5001iX, 9003iX and 15003iX only.

Parallel Operation:

Up to three units can be paralleled in a single-phase configuration
(with one master controller and one or two slave units). (10001iX
and 15001iX).

Three Phase Output:

Three units (all with single-phase controllers) can be connected in
a three-phase configuration using CLOCK and LOCK
connections. Requires –LKM option in master and –LKS option in
auxiliary units. Recommended is use of 9003iX, 15003iX or
30003iX three phase system however.
Note: Clock and lock operation is not supported between Series I
and Series II controller types. For this mode of operation, both
models have the have the same controller type.

Controller:

Programmable controller front panel assembly.

Output Relay:

Standard output relay feature to isolate AC source from the load.

Output On/Off:

The output relay can be used to quickly disconnect the load. A
green status indicator displays the status of the output relay.

Three-Phase Output
9003iX/15003Ix

Three power sources with one controller in the Phase A power
source. The one controller controls all three outputs.

15003iX – LKM/-LKS

Three power sources each with a controller for 3-phase output

Option

Description

Note

Avionics and IEC test options not available on iM Series models.

- 704

Mil Std 704D & E test firmware.

Mil Std 704A, B, C, & F test software (refer to Avionics Software
Manual P/N 4994-971 for details).
Note: Requires use of CIGuiSII Windows application software
provided on CD ROM CIC496.

- 787

Boeing 787 Test software (refer to Avionics Software Manual P/N
4994-971 for details).
Note: Requires use of CIGuiSII Windows application software
provided on CD ROM CIC496.

- 160

RTCA/DO-160D test firmware

RTCA/DO-160E test software (refer to Avionics Software Manual
P/N 4994-971 for details)..
Note: Requires use of CIGuiSII Windows application software
provided on CD ROM CIC496.

- 411

IEC 1000-4-11 test firmware

- 413

IEC 1000-4-13 test hardware and firmware

-ABD

Airbus ABD0100.1.8 Test software (refer to Avionics Software
Manual P/N 4994-971 for details)..
Note: Requires use of CIGuiSII Windows application software