HITEC Lynx 4S - Manual (Page 5)

MANUAL:
SECTION 1
P5
Always check the transmitter’s throttle trigger to be sure it rests in a neutral position before powering “ON”
your system. Make sure your model’s engine is not running when powering down.
Always turn the transmitter power switch on first before turning on either the receiver or speed control. Re-
verse the order when powering down: be sure to turn off the receiver and speed control first, then power off
your transmitter.
Always set up the fail safe function. The fail safe function is a safety feature that minimizes damage by moving
the servos to a preset position when reception fails.
When the Lynx 4S is not being used, always remove or disconnect the battery to prevent personal injury or
property damage.
Do not drop the battery or subject it to jarring vibrations or extreme temperatures.
Do not leave the radio system or models within the reach of small children.
Leakage from the battery may potentially result in skin burn, loss of sight, and other injures. If exposed, thor-
oughly rinse the affected area and contact your doctor for proper treatment response.
Use approved transmitters, receivers, servos, ESCs (electronic speed controls), Ni-MH/Ni-CD batteries and
other optional accessories ONLY. Hitec is not responsible for issues that arise from the use or misuse of
equipment not specified in this instruction manual or our catalog.
Always exercise proper care in the use and storage of your Hitec product. Exposure to vibration, dust, or ex-
treme temperatures may affect its functionality and your safety.
Safety Precaution (cont.)