HITEC Lynx 4S - Manual (Page 40)

P40
MANUAL:
SECTION 3
RX-Bind (Receiver Binding)
The Lynx 4S is only compatible with Hitec AFHSS Surface Receivers.
Please select the approproate receiver according to your receiver type.
AXION 2: Will bind with AXION 2
AXION 4: Will bind with AXION 4
PROTON 4: Will bind with PROTON 4
NORMAL: 14ms (Digital / Analog servo compatible)
HIGH SPEED: 7ms (Only compatible with Digital servo)
HHR SYSTEM: 4ms (Only compatible with Digital servo & Axion 2 )
Prevent serious damage to analog servos; DO NOT SELECT HIGI SPEED OR HHR SYSTEM with analog servo receivers.
Note
Tip Tip
Tip
Use the RX-BIND process when you have purchased multiple receivers or need to reset those receivers from
a previous bind. RX-BIND “binds” the transmitter to the receiver so they operate as a unit pair.
The Lynx 4S stores up to 30 models in its memory, which means users can bind up to 30 receivers to their
Lynx 4S and control each one of them independently.
Bind with AXION 2 Bind with PROTON 4
Please place the Lynx 4S and receiver(s) within a 1 meter distance while binding.
Note
Tip Tip
Tip
Ex) Bind with AXION 2 Ex) Bind with PROTON 4