HITEC Lynx 4S - Manual (Page 11)

MANUAL:
SECTION 1
P11
Installing the Extension Adapter (included) gives you the option of changing the location of the steering wheel.
The adapter improves comfort control for the Lynx 4S by allowing the steering wheel unit and throttle trigger
to be positioned at the same level.
Disassembling the Steering Wheel Unit:
You will need a Phillips screwdriver to complete the following procedure. Do not force the bolts together or apart if
you encounter resistance as you can damage the unit. Work with the bolts until they slide easily into position.
Note
Tip Tip
Tip
3x28mm Screw Bolt
Wheel Sponge
Steering Wheel
2.6x12mm Screw Bolt
Wheel Cover
1. Lift the groove under the steering wheel cover to remove it.
2. Loosen the 2.6 x 12mm screw bolt affixed to the steering wheel.
3. Pull the steering wheel adapter apart by hand to separate.
4. Loosen each of the three 28mm screw bolts from the wheel unit.
5. Disconnect the cable attached to the Steering Gimbal unit.
Changing the Position of the Steering Wheel