HITEC Lynx 4S - Manual (Page 45)

MANUAL:
SECTION 3
P45
Sensor (Telemetry Sensor Setup cont.)
The GPS sensor is unavailable indoors. Please note that there may be a difference between GPS speed and actual
speed depending on mileage.
Note
Tip Tip
Tip
To use the ‘SPEAK’ function, a micro SD memory card is required. It is recommended that users save their warning
files to the micro SD memory card provided through the Hitec website. Please visit page _____ for more details.
Note
Tip Tip
Tip
SPEED (GPS or RPM Sensor):
Data from your GPS or RPM sensor will be displayed on-screen. In this section, users are shown how to set a
SPEED warning level and voice output.
SPEAK: Activate to issue an audio warning via the Lynx 4S speakers.
SOURCE: Users have two options, GPS or RPM.
UNIT: Set the unit of speed (MPH or KPH).
USE: Issues a warning message when activated.
WARNING: Set the desired warning level.
1. Press Main Dial to access the function menu.
2. Select ‘SERVO’ under the SYSTEM tab.
3. Select ‘SPEED’ from the menu and adjust the options to your preference.
There will be a time delay between the read-out of the audio data and when the data is displayed on-screen.
Note
Tip Tip
Tip
This function is only available when a Proton 4 receiver is used.
Note
Tip Tip
Tip