HITEC Lynx 4S - Manual (Page 26)

P26
MANUAL:
SECTION 2
FAIL-SAFE
Engaging the Fail-Safe option will move servos to a pre-saved position should you experience signal
interference. As a safety precaution, it is highly recommended that the Fail-Safe mode is activated at all times.
Hold Mode (HOLD):
Servo will maintain its current position when the receiver is not capable of receiving signals.
Set up Mode (SET):
Servo moves to a pre-set position when the receiver is not capable of receiving signals.
1. Press the Main Dial button to access the function menu.
2. Select FAIL-SAFE under the SET 1/2 tab by using the Main Dial button’s scroll and click functions.
3. Select HOLD or SET mode as desired after choosing the channel to be changed.
4. Adjust the location of the servo under the ‘FAIL-SAFE ON’ condition by using the trigger, dial, or switch.
5. To save the current FAIL-SAFE value, press the Main Dial button for a count of a few seconds.
6. After you finish adjusting the settings for each channel, press [SEND] and check the Sending display that will
confirm the settings you selected.
The FAIL-SAFE function automatically returns to the default set position when the user changes the type under
MIX function. Please re-set the FAIL-SAFE function when this happens. We recommend engaging the brakes to stop
engine-powered vehicles and backing off the throttle to stop electric models.
Note
Tip Tip
Tip