AMT Datasouth Performax - Manual (Page 92)

‘G7 Diagnostics’
‘Print Profile’
and compare the output to your desired configuration. If no changes are needed, rerun the print job.
If problem persists, go to the Symptom Table and locate the symptom that best describes the
problem you are experiencing. Perform the corrective actions listed for the symptom. If the problem
still exists after performing the corrective actions, or if there is not a symptom that corresponds to
the problem you are experiencing, call a qualified technician for further assistance.
In the following table, some corrective actions indicate to the operator to check a ‘Feature Value’ to
make sure it is set correctly. An incorrect feature value can vary between host systems, applications,
configurations, etc., and may cause the particular symptom. For example:
‘G5 Parallel Ctrl’
‘Parallel Enabled’
The operator may need to check the setting of the Parallel Enable/Disable feature found under
Group 4 (Parallel Control), and verify that the Parallel port is Enabled.
5-17
Troubleshooting Table