AMT Datasouth Performax User Manual
Page 12
2.
Remove shipping thumb screws (see figure on page 1-6).
3 .
Remove clip securing carriage belt (see figure on page 1-7).
4.
Use the printhead adjustment lever on the top right hand side of the printer to move
printhead away from the platen.
5.
Install ribbon cartridge.
6.
Install power cord.
WARNING
CONNECT 115V UNITS TO 115V OUTLETS ONLY!!
7.
Turn printer on.
8.
Position left tractor. Align pins with first mark (see page 2-5). Position paper guides, one
next to each tractor and one in the middle of the form.
9.
Place paper in tractors. For paper less than 8.5 inches wide see Forms Setup Procedure, page
2-5.
CAUTION
IMPROPER MARGIN SETTINGS CAN LEAD TO PRINTHEAD DAMAGE!!
DO NOT PRINT OVER TRACTOR HOLES OR OFF PAPER EDGE.
10. Press the Load key. Move forms adjustment lever all the way forward (to the rear of the
printer), then back two detents for single part paper. For multi-part forms see page 2-13.
11.
Press the Setup key.
12. Press the Feature key once to select Self-Test.
2
13. Press the Enter key.
This will start the printer self test. The test may be stopped by pressing the On/Off Line key, or the
Enter key.