AMT Datasouth Performax - Manual (Page 58)

3. Press the Setup key and follow the previously Print Profile
described procedures for changing features. Go to
Group 7. The display will read:
4-4
4. Make certain 8 ½ inch or wider paper is loaded in the printer.
5. Press the Enter key. The printer will print a listing of the profile feature settings.
6. Press the Setup key to exit setup mode.
7. Press the On Line key to return to normal operation.
Changing Features In A Profile
Feature settings in a profile may be changed through the keypad by following the steps below:
1. Press the Off Line key. (The On Line light should be off.)
2. Press the Setup key. (The G1 Forms Control
Setup light will be on.) Form Length XXX
The display will read:
NOTE
If you are unable to enter setup mode, contact your system manager.
(The display will read “Key Lock”.)
3. Press the Group key, as necessary, to scroll through the feature groups until you reach the
group containing the feature you wish to change.
NOTE
Features and values are listed by group, on pages 4-9 through 4-23.
4. Press the Feature or Feature key to scroll the display up or down until you reach the
feature to be changed.
5. Press the Value key or Value key to scroll the display backward or forward until you
reach the value you wish to set.