AMT Datasouth Performax - Manual (Page 85)

When the ribbon usage value reaches 0%, all printing will stop and the following message will
appear in the display:
< Ribbon Life End>
1. Open Cover
To recover from this error, replace the ribbon as follows:
1. Open rear cover. The 2. Replace Ribbon
display will change to the 3. Close Cover
message as shown.
2. Replace ribbon cartridge
and close the cover. The
Ribbon Replaced?
display will change to the Y = Setup N = On Line
message as shown.
3. Press the Setup key (Y) to reset the ribbon usage value to 0% and resume normal operation.
Cover Open
If any of the cover sections are open (front access, rear cover or tear bar), the following message is
displayed:
< Cover Open >
Close To Cont.
To recover from this error condition:
1. Close the cover section which is open. The following message is displayed.
Ribbon Replaced?
Y = Setup N = On Line
5-10
2. Press the On Line key to continue operation. If a new ribbon cartridge has been installed,
press the Setup key. This will reset the Ribbon Life Monitor feature.