AMT Datasouth Performax - Manual (Page 60)

4. Press the Value key to GI Forms Control
change the Lines/inch to 8 Lines/Inch 8
lines.
4-6
5. Press the Enter key to save
the new Lines/Inch value.
The bell will sound once.
6. Press the Setup key to exit Save Profile?
setup mode. The “Save Y=Enter N=Setup
Profile” message will be
displayed.
7. Press the Enter key. This P1 Profile One
records the change into the Font DP10
profile.
8. Press the On Line key to P1 Profile One
place the printer back on Font DP10
line.
9. Press the Load/Park key to reset top of form.
After pressing the On Line key, the printer will operate with the vertical motion defined as 8 lines
per inch. The next time this profile is selected, or if the printer power is switched off and back on,
the lines per inch margin will remain at 8 lines per inch.
G1 Forms Control
Lines/Inch
8
G1 Forms Control
Lines/Inch
8
G1 Forms Control
Lines/Inch
8
G1 Forms Control
Lines/Inch
8