Appendix d: system administration features – AMT Datasouth Performax User Manual
Page 119
C-4
Appendix D: System Administration Features
This appendix describes how to access features which are not normally available while the printer is
in Setup Mode. These features are found in a hidden group called “G8 System Ctrl”.
By accessing this hidden group, you may:
Reset all profiles to factory defaults and reset the Key Lock Out feature to factory defaults.
Selectively lock out or delay individual keypad functions such as “Setup Mode” using the
Key Lock Out feature.
Set the ribbon life monitor check and replace limits.
NOTE
Use of these features may be restricted by
removing this appendix from the manual.
To access this hidden group, do the following:
1.
Load paper in the printer and place the printer On Line (On Line LED ON).
2.
Press the four keys in the order indicated below.