AMT Datasouth Performax - Manual (Page 83)

The display will appear as shown:
Ribbon Replaced?
Y = Setup N = On Line
8. Make certain all sections of the cover set are closed or the printer will not exit the carriage
jam mode.
9. Press the On Line key. When the On Line key is pressed, the printer resets the carriage,
checks the paper path, and the error message is cleared from the display. The printer will
indicate a paper out condition if the paper needs to be reloaded.
If the ribbon was replaced, press the Setup key. This will reset the Ribbon Life Monitor.
10. Reposition the printhead for normal operation.
Parity Error
The serial interface requires the printer to operate with the same parity status as the host computer.
If parity has not been set correctly at the printer, the following error message is displayed.
< Parity Error >
To recover from this error, first determine what the parity setting for the printer should be by
referring to the documentation for your host computer. The correct parity setting should then be
made as follows:
1. Press the Off Line key. P1 Profile
One Font DPI0
5-8
2. Press the Setup key. The G1 Fonts Control