AMT Datasouth Performax User Manual

Page 107

Parallel Interface Enable/Disable

Set the power switch to ON.

Press the Off Line key.

Press the Setup key. The first group
will appear on the top line of the
display, with the first feature of the
group appearing on the bottom line.

Press the Group key until you have
accessed Group 5. The display will
appear as shown.

Press the Feature key to select
the Parallel feature.

Press the Value key to select Enable.
Press the Value key to select Disable.

Press the Enter key to accept your
selection.

There are three additional features which allow you to configure the parallel interface to suit your
needs: Handshake, ACK BUSY and 8th Bit. All three features are contained in Group 5, Parallel
Control. Each feature is explained in detail in Chapter 4. After you finish your parallel interface
configuration, continue with Step 8.

Press the Setup key to exit
setup mode. The “Save Profile”
message will be displayed.

B-6

P1 Profile One
Font DP10

G1 Forms Ctrl
Form Length 66

G5 Parallel Ctrl
Handshake Busy

G5 Parallel Ctrl
Parallel Enable

G5 Parallel Ctrl
Parallel Disable

Save Profile
Y=Enter N=Setup