AMT Datasouth Performax - Manual (Page 59)

4-5
6. Press the Enter key to record the new value. The bell will sound once.
7. Repeat steps 3 through 6 as necessary until all features are correctly set for your application.
8. Press the Setup key to exit
setup mode. The display
Save Profile?
will read: Y=Enter N=Setup
To answer “Yes”, press the Enter key. This will record the change in non-volatile memory for that
profile.
To answer “No”, press the Setup key. This will make the change temporary, thus not changing the
original profile setting. These settings will be valid until profiles are changed again or the printer is
powered off.
9. Press the On Line key to return to operation.
NOTE
To maintain correct top-of-form alignment when a profile change is made,
the paper should be parked (if not already parked) and reloaded so that the
printer can reset the top-of-form for the new profile.
As an example, assume the profile you are presently using defines the lines per inch as 6. To
permanently change the lines per inch to 8, proceed as follows:
1. Press the Off Line key. P1 Profile One
Font DP10
2. Press the Setup key to GI Forms Control
enter setup mode. Form Length 66
3. Press the Feature key to GI Forms Control
select Lines/inch. Lines/Inch 6