AMT Datasouth Performax User Manual

Page 44

Text mode
Original mode

Run the printer self-test (Maintenance Troubleshooting section).

Inspect the print sample. The characters should be easily read with no missing dots. Make
certain you check the last copy of multi-part forms for properly formed characters.

If the print quality is unacceptable,
move the print- head closer by one
detent position and run another print
sample (step 4).

NOTE

There is not a direct correlation between detent position and the number

of parts in a multi-part form (e.g. the adjustment control is not set to the

fourth mark for a four-part form).

Repeat this procedure until acceptable print quality is obtained.

2-13

Changing From Continuous Forms to Cut Sheets