AMT Datasouth Performax User Manual

Page 2

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause

undesired operation.

WARNING

CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY

THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S

AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, way cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the interference at his
own expense.

NOTE

When connecting the printer to a host computer system, always use shielded interface cables.
The use of non-shielded interface cables is a violation of the FCC emissions limits for a Class
A computing device. Do not leave unterminated interface cables connected to the printer.

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites
applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le brouillage
radioelectrique edicte par le ministere des Communications du Canada.