SilentKnight 5600 - Manual (Page 85)

System Operation
151450 7-9
Trouble A system
trouble
condition
occurs. The dialer seizes control of the phone
line and calls the central station.
The remote annunciator sounds a
loud, pulsing beep in the sequence
one second on, nine seconds off.
TROUBLE LED flashes.
The LCD displays a screen similar to
this one.
Press down arrow to view the trouble. A screen
similar to this one displays.
Activate the key by turning it to the ON position
then press the Silence key to silence the
Remote Annunciator.
Once the trouble condition has been fixed, the
system will restore itself automatically.
Reset
The
button is
pressed while
the key is
activated.
All LEDs are on briefly then the LCD
displays “RESET IN PROGRESS”. If
the reset process completes normally,
the date and time normal mode screen
displays.
Silenced An alarm or
trouble
condition has
been silenced
but still exists.
To silence
alarms and
troubles, press
while the
key is
activated.
SILENCE LED is on. TROUBLE,
SUPERVISORY or GENERAL ALARM
LED (depending on condition) is on.
The annunciator (and any notification
devices attached to the system) will be
silenced. Press down arrow to view the location of the
alarm or trouble. When the condition no longer
exists, the SYSTEM SILENCED and SYSTEM
TROUBLE LED, SUPERVISORY or GENERAL
ALARM LEDs turn off.
Table 7-1: Operation Modes of Remote Annunciator
Operation
Mode
Occurs When System Behavior In This Mode You Can