SilentKnight 5600 - Manual (Page 84)

Model 5600 Installation and Operation Manual
7-8 151450
7.22 Operation Mode Behavior
The remote annunciator can be in one of six conditions at any given moment: Normal,
Alarm, Supervisory, Trouble, Silenced, and Reset. Table 7-1 describes the behavior
of the Remote Annunciator in each of these modes.
Table 7-1: Operation Modes of Remote Annunciator
Operation
Mode
Occurs When System Behavior In This Mode You Can
Normal No alarm or
trouble
condition
exists. AC POWER LED is on.
The All Systems Normal display
indicates that the system is in normal
mode.
The current date and time display on
the last line of the LCD.
Alarm A smoke
detector goes
into alarm or a
pull station is
activated. The dialer seizes control of the phone
line and calls the central station.
The Remote Annunciator sounds a
loud, steady beep (any notification
devices attached to the system will
also sound).
ALARM LED flashes.
The LCD displays a screen similar to
this one.
Press the down arrow to view the alarm. A
screen similar to this one displays.
Activate the key by turning it to the ON position
then press the Silence key to silence the
Remote Annunciator (and any notification
devices attached to the system).
When the alarm condition clears, activate the
key and press Reset to restore the panel to
normal.
Supervisory The system
detects a
supervisory
condition. The dialer seizes control of the phone
line and calls the central station.
The Remote Annunciator sounds a
loud, pulsing beep in the sequence
one second on, one second off.
SUPERVISORY LED flashes.
The LCD displays a screen similar to
this one.
The LCD displays a screen similar to
this one.
Press down arrow to view the supervisory
condition. A screen similar to this one displays.
Activate the key by turning it to the ON position
then press the Silence key to silence the
Remote Annunciator.
Once the supervisory condition has been
corrected, the system will restore itself
automatically.