Red start/stop cable (1b to bnc), Red 3-axis system operation guide – RED 3-AXIS LENS CONTROL SYSTEM User Manual
Page 68
COPYRIGHT © 2014 RED.COM, INC
RED 3-AXIS SYSTEM OPERATION GUIDE
955-0044, REV-D | 68
RED START/STOP CABLE (1B TO BNC)
The RED Start/Stop Cable (1B to BNC) provides Start/Stop, Genlock, and Timecode support. This cable con-
nects to the EXP port on the W.M.D. and an auxiliary device for Start/Stop, Genlock and Timecode.
NOTE: Full support requires the 3BNC-to-00 LEMO Sync Cable and a BNC-TO–BNC Adaptor (included with the
RED 3-Axis Lens Control System).
W.M.D. EXPANSION PORT
EPIC START/STOP
FGG-1B.314.CLAD42Z
BNC
PIN
SIGNAL
WIRING
PIN
SIGNAL
1
GND
1-Shield
Shield
GND
2
232_Rx
-
Coax
EPIC Start/Stop
3
+12 V
-
-
-
4
232_Tx
-
-
-
5
Momentary
Start/Stop
-
-
-
6
EPIC Tally
-
-
-
7
EPIC Start/Stop
7-Coax
-
-
8
AUX GPIO 1_3.3
-
-
-
9
+3.3 V
-
-
-
10
Cable ID
-
-
-
11
-
-
-
-
12
AUX GPIO 2_3.3
-
-
-
13
-
-
-
-
14
-
-
-
-
RED Start/Stop Cable (1B to BNC)