CK Electric Part C3000 - Manual (Page 165)

8-6 Setup and Other Utilities in the Desktop Manager Chapter 8
MPC-3000—USERS MANUAL/V000/07-97
❍ Error Correction (ECM)
You select this option to reduce system and line errors when
sending a fax. With this option selected, the system checks each
outgoing fax for lost data. If data has been lost from a portion of a
page, the system transmits that portion again after confirming that
all data within that portion can be transmitted successfully.
❍ Auto Start Send
When you select this option, the MultiPASS C3000 starts scanning
automatically five or ten seconds after you enter a phone number.
When you don’t select this option, you must press
START/COPY
to
scan the document, or the unit returns to standby mode after 60
seconds.
❍ Off Hook Alarm
You select this option to turn on the alarm if the telephone’s
handset is off hook.
❍ Image
You select a contrast setting that determines the level of contrast in
the faxes you send. The Standard setting is usually appropriate for
most documents. However, based on the lightness or darkness of
your original fax document, you may prefer to lighten or darken the
contrast for the fax transmission.
❍ Fax Heading
You select the position where you want the sent fax heading
information (your fax number, your name, and date and time) to
print on the faxes you send. This information is known as the
Transmit Terminal Identification (TTI). It can be printed either
inside or outside the image area of your fax page.
❍ On Error
You select Resend option if you want the MultiPASS C3000 to
automatically redial when an error occurs while sending a fax. You
also select which pages are to be resent: only the page on which the
error occurred, the page on which the error occurred and the first
page of the fax, or all pages.