Session-timeout (iscsi) – Cisco OL-15491-01 User Manual
Page 237
A-237
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
session-timeout (iSCSI)
session-timeout (iSCSI)
To specify the session timeout for an iSCSI target in the target interface profile on the CSG2, use the
session-timeout command in iSCSI configuration mode. To restore the default timeout, use the no form
of the command.
session-timeout duration
no session-timeout
Syntax Description
Command Default
The default iSCSI target session timeout is 60 seconds.
Command Modes
iSCSI configuration
Command History
Examples
The following example configures an iSCSI target interface profile with the name targetA with a SCSI
session timeout of 120 seconds:
ip iscsi target-profile targetA
name iqn.2002-10.edu.abc.iol.iscsi.draft20-target:1
ip 10.0.0.1
port 3260
session-timeout 120
target-portal 1
Related Commands
duration
Number of seconds the iSCSI initiator waits for a response from the iSCSI target, after
which it closes the iSCSI session. The range is from 1 to 600. The default setting is
1 second.
Release
Modification
12.4(15)MD
This command was introduced.
Command
Description
Specifies the IP address of an iSCSI target in the target interface
profile on the CSG2.
Defines the delay interval, in seconds, before draining packets from
the Storage Area Network (SAN) connected to the Internet Small
Computer Systems Interface (iSCSI) when the Billing Mediation
Agent (BMA) becomes active.
Defines the number of packets to be drained from the Storage Area
Network (SAN) connected to the Internet Small Computer Systems
Interface (iSCSI) per drain delay interval when the Billing Mediation
Agent (BMA) becomes active.