Cisco OL-15491-01 - Manual (Page 196)

A-196
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
meter include imap
meter include imap
To specify which Internet Message Access Protocol (IMAP) bytes are billed for by the CSG2 when doing
prepaid debits, use the meter include imap command in CSG2 service configuration mode. To return to
the default behavior, use the no form of the command.
meter include imap body {header | only | other}
no meter include imap
Syntax Description
Defaults All IMAP bytes are to be counted when performing prepaid debits.
Command Modes CSG2 service configuration
Command History
Usage Guidelines You can configure only one meter include imap command per service. The billing basis for the service
must be byte. The three categories of bytes are BODY, HEADER, and OTHER, determined as follows:
• BODY—The bytes are classified as BODY if a fetch request or response is encountered for one of
the following specifications (including any appended “<>” subset variants):
– BODY[]
– BODY[#]
– BODY[TEXT]
– BODY[#.TEXT]
– BODY.PEEK[]
– BODY.PEEK[#]
– BODY.PEEK[TEXT]
body header Only BODY and HEADER IMAP bytes are to be counted when
performing prepaid debits.
body only Only BODY IMAP bytes are to be counted when performing prepaid
debits.
body other Only BODY and OTHER IMAP bytes are to be counted when
performing prepaid debits.
Release Modification
12.4(11)MD This command was migrated from CSG1.
Changes from CSG1:
• The name of this command changed from meter imap to meter include imap.
• The body-header, body-only, and body-other keywords changed to body
header, body only, and body other, respectively.