EVCO c-pro micro SAVE - Manual (Page 46)

C-PRO MICRO SAVE APPLICATION MANUAL
Page 46
7.4 Alarms log
The controller record the ALARMS LOG in a non-volatile area of the memory organised as FIFO
(First In First Out), that is a list of the last 100 alarms occurred.
To display the alarms log, select LOG from the General menu or press ESC from the main page to
display this page:
Move the cursor on “Show HISTORIAN>>>” and push the Enter key. The alarms log screen will
be displayed:
Each element of the log has the following information associated:
- Alarm running number
- Alarm mnemonic code (AL01, AL03, …)
- Alarm occurrence date and time
- A possible value associated to the alarm
The alarm mnemonic code is the one shown in the alarms table. The log can hold 100 events.
Via the PH18 (Delete alarms log) parameter it is possible to cancel all the alarms stored in the log.
Set the parameter at SI (1) and wait a few seconds for the NO (0) default value to be read again.
Note 1: The storing in the log of an alarm beyond the maximum number allowed (100) means the first alarm of the log
is overwritten.