EVCO c-pro micro SAVE - Manual (Page 22)

C-PRO MICRO SAVE APPLICATION MANUAL
Page 22
COMPLETE VERSION
Alarm icon: appears when there are
active alarms. If all of them have been
viewed
the icon becomes fixed,
otherwise (some active alarms not
viewed) the icon keeps flashing.
From the main page it is possible to access the state pages by pressing the RIGHT key. Pressing
ESC it’s possible to go to the page for displaying the alarms and log.
4.2.9 State Pages
From the main page it is possible to scroll the free access pages, which show the states of the
controlled devices. These pages are not protected by password and can only be accessed with unit
ON. To display them, press the LEFT and RIGHT keys.
Note: If some devices are disabled from parameter, the information regarding their working status is replaced with dots
“…” in order to avoid filling the state pages with information not enabled by the control. The same is valid for the
disabled probes.
4.2.10 Alarm pages
To display the alarms, select “Show ALARMS>>>” from the general menu or press ESC from the
main page to display this page:
Position the cursor on “Show ALARMS >>” and then press ENTER key.
If no alarms are present the writing “NO ALARS” is displayed. Otherwise every time ENTER key is
pushed the next active alarm is displayed.
For resetting the alarm, in case the alarm condition is expired, keep pushed the ENTER key for
about 2 seconds. If the alarm cause is still active the alarm is not reset and the current mask remains
displayed.
If the ESC key is pressed on an alarm page or you wait 60 seconds for timeout, go back to the main
page of the application. This level is not protected by a password.
Air temperature set point for main temperature
control (supply/return)
Information regarding the fans working mode:
- COMFORT: Comfort period automatic control
- COMFORT+P.: Comfort period automatic control
WITH presence sensor active.
- ECONOMY: Economy period automatic control.
- ECONOMY+P.: Economy period automatic control
WITH presence sensor active.
- NOT WORKING DAY: Automatic control during
not working days
- RTC ERROR: Automatic control during RTC error
- MANUAL: Manual control
- CO
2
SENSOR: Control based on CO
2
sensor readout