1 foreword – EVCO EVFTFT818P7U Installer manual User Manual
Page 71
EVCO S.p.A.
EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 71 of 94
12
USE OF THE USB PORT (ONLY AVAILABLE IN
THE MODEL EVFTFT818P7U)
12.1
Foreword
Through the USB port it is possible to make the following operation (from and in a text document):
-
upload and download of the configuration parameters
-
upload and download of the programs
-
download of the information relative to the HACCP alarms.
The upload / download procedures are allowed on condition that the firmware of the device of origin and the one of the
device (or the devices) of destination are coincident.
The procedures are guaranteed if using the EVCO USB peripheral EVUSB4096M.
12.2
Upload
and
download
of
the
configuration
parameters
To make the download of the configuration parameters operate as follows:
1.
Make sure the device is in the “stand-by” status.
2.
Insert an USB peripheral in the USB serial port.
3.
Press and release the
key (1) to select “DOWNLOAD PARAMETERS”, then press and release the
key
(2): it will automatically be started the writing (into the peripheral) of a text document by name “param.txt”
(containing information about the configuration parameters); the writing procedure can take some minutes.
4.
To the end of the download remove the USB peripheral from the USB port.
To make the upload of the configuration parameters operate as follows:
5.
Make sure the device is in the “stand-by” status.