EVCO EVFTFT818P7U Installer manual - Manual (Page 60)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 60 of 94
r13 -99 99 °C/°F (1) 15
end temperature of the temperature-controlled hard blast
chilling phase (temperature detected by the needle probe)
r14 10 100 % 60
duration of the time-controlled hard blast chilling phase
(intended as a percentage of the value established with
parameter r1); also duration of the time-controlled soft
deep freezing phase (intended as a percentage of the value
established with parameter r2)
r15 -99 199 °C/°F (1) 65
temperature below which the count of the maximum
temperature-controlled blast chilling and maximum
temperature-controlled deep freezing is started
(temperature detected by the needle probe)
r16 0 2 - - - - 1
type of operating cycle that can be selected
0 = blast chilling and storage
1 = blast chilling and storage or deep freezing and
storage
2 = deep freezing and storage
r17 0 99 °C/°F (1) 5
"temperature detected by the needle probe - cabinet
temperature" minimum difference such to consider the first
phase of the test to verify correct insertion of the needle
probe completed successfully (consider the difference
without sign)
0 = the test will not be performed (neither first or second
phase)
r18 1 99 s 60
duration of the second phase of the test for verification of
correct insertion of the needle probe
r19 - - - - - - - - - - - - - - - - reserved
Par. Min. Max. Unit Default Compressor protections
C0 0 240 min 0
minimum time between restoring the power supply after a
power cut, occurring during an operating cycle and
compressor switch-on
C1 0 240 min 5
minimum time between two consecutive compressor switch-
ons (3)
C2 0 240 min 3
minimum time between compressor switch-off and
successive switch-on (3)
C3 0 240 s 0 compressor switch-on minimum duration