EVCO EVFTFT818P7U Installer manual - Manual (Page 55)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 55 of 94
3. Press and release the HOME key (1), press and release the MENU key (2) and then press and release the
key repeatedly (3) in order to select the “PARAMETERS”.
4. Press and release the key (4), repeatedly press and release the key (5) to set “-19”and then press and
release the key (6) again.
Operate as follows to select a parameter:
5. Press and release the key or the key.
Operate as follows to set a parameter:
6. Press and release the key or the key.
Operate as follows to exit the procedure:
7. Press and release the ESCAPE key or do not operate for 60 s.
Cut the device power supply off after setting the configuration parameters.
11.3 Restoring the factory settings
11.3.1 Access to the procedure
Operate as follows:
1. Make sure that the instrument is in the “stand-by” status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.