EVCO EVFTFT818P7U Installer manual - Manual (Page 51)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 51 of 94
3. Press and release the HOME key (1), press and release the MENU key (2) and then press and release the
key (3) in order to select the “HACCP ALARMS”.
4. Press and release the key (4) and then press and release the key (5) or the key (6) to select the
alarm (the greater the number that follows the alarm code, the older the alarm).
5. Press and release the key: the device will display the information relative to the alarm.
6. Press and release the key or the key to display the information of the previous alarm or the successive
alarm.
Operate as follows to exit the procedure:
7. Press and release the ESCAPE key or do not operate for 60 s.
9.3 Deleting the information relative to the HACCP
alarms
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.