Brother MFC7000FC - Manual (Page 131)

............ ■'■v^.................. 'SWy»»***
^ T R O U B L E S H O O T I N G A N D . - M A I N T E N A N C E
j£L^
123
10 After installing the ink cartridges, close the top cover. Your MFC prepares for a
“head cleaning” and goes online. The display screen prompts you to verify a
new ink cartridge was inserted for each color you removed. Example:
DID
YOU CHANGE BLACK 1. YES 2. NO.
It the ink cartridge you installed is not a brand new one, please make sure to
select 2.
n
For each new cartridge. Press Q] on the keypad to reset the ink dot counter
for that color automatically. (The ink dot counter enables the MFC to notify
you when a color is running low.)
The MFC will enter a cleaning cycle for ^proximately one minute for each
replaced cartridge. The display screen alternately shows CLEANING and
PLEASE WAIT.
When the MFC completes the cleaning cycle, the display returns to Standby
mode (date and time).
A
WARNING
If ink gets in your eyes, irrigate them with water immediately and consult a
doctor if you are concerned.
o
Caution
■ DO NOT remove ink cartridges if you do not need to replace them. If you do
so, it may reduce the ink quantity and the printer will not know the quantity
of ink left in the cartridge.
■ DO NOT shake the ink cartridges. If you do so, the ink may spill when you
take off the sealing tape.
■ If ink stains your body or clothing, wash with soap or detergent immediately.
■ If you install an ink cartridge in the wrong color position, you must clean
the print head several times before you start printing after correcting the
cartridge installation because the colors were mixed.
■ Once you open an ink cartridge, install it in the MFC and use it up within six
months of installation. Use unopend ink cartridge within two years of
production.
Note: If the INK empty error mess^e is on the display after you have installed
ink cartridges, check that the ink cartridges are installed correctly.