Yamaha FX900 - Manual (Page 50)

BULK OUT
When this function is called the LCD will appear as shown below, and it becomes possible to execute a bulk data dump of a single
memory location (MEM), the system setup data (SYS), the program change assignment table of a single bank (BNK), or all of the
above (ALL) via the MIDI THRU/OUT connector.
5 3
1. Make sure that the rear-panel MIDI THRU-OUT switch is
set to the "OUT" position.
2. Use the [UTILITY] key to select the BULK OUT display.
The underline cursor should be under the ALL
parameter.
BULK OUT ALL SYS
mem : * bnk :»
NOTE: Refer to the MIDI DATA FORMAT section beginning
on page 160 for more details about the bulk dump
data.
NOTE: "++ MIDI RECEIVE" will appear on the upper display
line during bulk data reception.
3. Use the cursor [ ◄] and [ ►] keys to select the type of
data you want to transmit:
ALL = All program, system setup, and program change
table data.
SYS = System setup data (i.e. current utility settings,
etc).
MEM = The data for the specified memory location.
BNK = The program change table data of the specified
bank.
4. If you select either MEM or BNK, use the [DATA ENTRY]
control or
[A]
and
[T]
keys to select the memory
location number (PRESET locations POO — P99, USER
locations UOO — U99) or bank (A, B, C, or D)
corresponding to the data you want to transmit.
5. Press the [STORE] key to execute the bulk dump
operation. A display similar to the following will appear
while the data is being transmitted.
BULK OUT
**
BULK OUT BANK
The initial BULK OUT display will reappear when
transmisison has finished.
49