Cdw — compressor/distortion/equalizer/wah, Compressor, Distortion – Yamaha FX900 User Manual
Page 27: Equaiizer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• CDW — Compressor/Distortion/Equalizer/Wah
This parameter-packed effect stage provides a chain of four independent effects — compressor, distortion, equaiizer, and wah.
COMPRESSOR
THR RAT ATK REL
-20 1/» 5.0 .20
DST TRG TON
100 -45 800
Determines how iong it takes for compression to begin after
an input signai is detected. Refer to page 19.
REL (Release: 0.01 — 2.0 sec)
Determines how long it takes for the compression to be fully
released after the input signal drops below the threshold
level. Refer to page 19.
MiG MiF HiG
+2 2.2k
0
TYP FRQ GAI Q
PEK 250
0 2.8
SEN CTR SPD LVL
5 AUT 7.5 0
Compressor
THR (Threshold: -24 — 0 dBl
Sets the compressor threshold level. Refer to page 19.
RAT (Ratio: 1/2.1/3.1/4.1/6.1/8.1M
This parameter sets the degree of compression. Refer to
page 19.
Distortion
DST (Distortion Drive Level: 0 — 2001
Sets the degree of distortion produced. Higher values
produce more distortion.
TGR (Noise Gate Trigger Level: -80 -- -iLOjiB)
Sets the threshold level of the distortion effect stage noise
gate. Refer to page 20.
TON (Low Pass Filter Cutoff Frequency: 100Hz — 8kHz)
Controls the tone of the distortion sound.
Equaiizer
Sets the amount of boost or cut applied to mid-band
frequencies.
26