FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual
Page 212

4 – Appendices
NET SatisFAXtion 8.7 Manual
212
ceive the post page response during this period. When the driver receives this
OK
it will send the
+FDT
signal and wait for a
CONNECT
or for a
+FHNG
.
get_send_pre_phase_ok_timeout_msecs [dword 0–65535]: This is how
long to wait for an
OK
while in the initial pre-phase of a fax send. When the
driver receives an
OK
it will send a
+FDT
. The modem usually receives
CSI
and
DIS
in this time period. Default:
35000
.
hangup_timeout_msecs [dword 0–65535]: This is how long to wait for
ATH0
command to complete. Default:
2000
.
line_type [string]: When
dtmf_prompt
is specified, the
dtmf_detection_be-
gin_string
will be sent at the start of the call and received DTMF digits will
be collected from the modem up until either a
dtmf_terminate_digit
is re-
ceived or a 6 second inter-digit timeout occurs or a CNG tone is detected or
dtmf_digit_count
number of digits are collected. Default:
NORMAL
.
hangup_timeout_msecs [dword 0–65535]: This is how long to wait for
ATH0
command to complete. Default:
2000
.
line_type [string]: When
dtmf_prompt
is specified, the
dtmf_detection_be-
gin_string
will be sent at the start of the call and received DTMF digits will
be collected from the modem up until either a
dtmf_terminate_digit
is re-
ceived or a 6 second inter-digit timeout occurs or a CNG tone is detected or
dtmf_digit_count
number of digits are collected. Default:
NORMAL
.
next_ring_response_timeout_msecs [dword 0–65535]: This is how many
msecs to wait after a ring from the modem before resetting the internal ring
counter. This will only apply for
rings_before_answer
greater than 1 and
when not using TAPI. Default:
7500
.
on_hook_msecs [dword 0–65535]: This is the minimum amount of time after
the modem goes on hook from a prior connection before the driver will start a
new connection (dial). This will allow the phone system to have time to discon-
nect the call upon noticing the modem on hook. Default:
200
.
pause_before_send_command_msecs [dword 0–65535]: This specifies how
long to pause when the protocol state is idle, answering, or dialing, before
sending the "
AT
" command. There are some modems that upon sending an
OK
from a subsequent command, must have time to get ready to receive new char-
acters from the
DTE
. Default:
100
.
periodic_reset_timeout_msecs [dword 0–4294967295]: How often a reset
sequence should be done to verify modem integrity. It is understood that some
modems may periodically hang or go into a disabled power saver type of mode
or that they may be turned off and on but the
DSR
modem control change is not
detected possibly because TAPI is being used. Therefore, the driver will reset
the modem when it is idle for this amount of time. Setting this to 0 will disable
this periodic reset feature. Default:
600000
.
receive_image_modulation_timeout_msecs [dword 0-65535]: How long to
wait without receiving any image data before canceling the reception of image
data. There is a USR modem that sometimes fails to send a
DLE
/
ETX
sequence