FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual
Page 175

4 – Appendices
NET SatisFAXtion 8.7 Manual
175
27977 Timeout waiting for invite final response:
Call was not answered in
the configured time period. Error type:
NO_ANSWER
.
27978 Unknown
SIP response code: Received nonstandard SIP code from
media gateway. See extended error code. Error type:
RETRYABLE
.
27979 Timeout waiting for reinvite to fax:
The call connected, but the
gateway failed to send a reinvite for T.38 either because there were no fax
tones detected on the remote side or because the gateway does not support
T.38. Error type:
RETRYABLE
.
27980 Timeout waiting for ACK of OK for reinvite to fax:
Media gateway
incompatibility or severe network issues. Error type:
RETRYABLE
.
27981 SIP response sent 7 times with no ACK: Media gateway incompati-
bility or severe network issues. Error type:
RETRYABLE
.
27982 Reinvite OK received without
T.38 media: Media gateway incompati-
bility. Error type:
RETRYABLE
.
27983 SIP bye received before fax was completed: The remote fax device
hung up before the fax was completed. The gateway also did not include a
Q.850 cause code for this disconnect, otherwise this would likely be 0x7210
Normal Call Clearing instead. Error type:
RETRYABLE
.
27984 Unable to open even
RTP port followed by consecutive RTCP
port. Error type:
NON_RETRYABLE
.
27985 No Answer, remote device did not respond to handshake:
The call
connected and T.38 communication was established, but the remote device
failed to respond to repeated attempts to handshake. This commonly occurs
when using T38_INVITE to initiate T.38 media without the initial RTP audio
phase. The timer is 35 seconds. Error type:
RETRYABLE
.
27986 Remote fax cannot receive:
The remote fax device is configured to
not receive faxes. Error type:
NON_RETRYABLE
.
27987 Can’t agree on bit rate:
The modem and the remote unit couldn’t fall
back to or agree upon any bit rate. This is most often caused by poor line condi-
tion. Error type:
NON_RETRYABLE
.
27988 Wrong response after training:
After sending 1.5 seconds of train-
ing data, the remote unit should have sent a CFR or FTT frame. It sent some-
thing else. Error type:
RETRYABLE
.
27989 No FTT or CFR received after 3 DCS/training sequences:
The call
connected and T.38 communication was established. The receiving and sending
devices exchanged CSI/DIS and TSI/DCS/training signals. After that, the re-
ceive side is expected to send a CFR (confirmation) or FTT (failure to train), it
did neither. Handshaking was attempted and failed twice more, at which point
IPFax terminated the call. Error type:
RETRYABLE
.
27990 No response after sending 3 end of page commands:
After reach-
ing the end of the page, IPFax sends an end-of-page command (MPS) and ex-
pects to receive an acknowledgment (MCF) from the remote device. IPFax did