FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 208)

4 – Appendices NET SatisFAXtion 8.7 Manual 208
cific setting, but you can set the default for all devices by specifying this under
the global icanfax section.
debug_show_output [string]: Debug output that displays various run time be-
havior of ICANFax. When specifying the
FAX_DEVICE , the ICANFax debug out-
put will be mixed in with the fax drivers debug output. This is a device specific
setting, but you can set the default for all devices by specifying this under the
global section. Format: One of the following values. Default:
NONE .
NONE
CONSOLE
FILE
FAX_DEVICE
SERIAL_CAPTURE
TCP
csid [string(20)]: The CSI for receive and the TSI for send.
allowed_receive_image_types [string]: These settings control the image
types that the device can send and receive via the T.30 protocol over the tele-
phone network. To receive or send some image types, the corresponding
al-
lowed_receive
/
send_transfer_type
setting must include ECM. Format:
Comma separated list of the following. Default:
1D,2D,T6,JBIG
.
1D
2D
T6
JPEG
JBIG
COLOR
200H_400V
300H_300V
400H_400V
allowed_receive_transfer_types [string]: These settings control the type of
fax and file transfers that the driver can perform for a device. Format: Comma
separated list of the following. Default:
FAX,ECM,V34 .
FAX
ECM
V34
allowed_send_image_types [string]: These settings control the image types
that the device can send and receive via the T.30 protocol over the telephone
network. To receive or send some image types, the corresponding
allowed_receive
/
send_transfer_type
setting must include ECM. Format:
Comma separated list of the following. Default: 1D,2D,T6,JBIG .
1D
2D
T6
JPEG
JBIG
COLOR
200H_400V
300H_300V
400H_400V