FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual
Page 173

4 – Appendices
NET SatisFAXtion 8.7 Manual
173
1350 Unspecified receive phase B error. Error type:
NON_RETRYABLE
.
1351 Response received error in receive phase B.
Error type:
NON_RETRYABLE
.
1352 Command received error in receive phase B. Error type:
NON_RETRYABLE
.
1353 T.30 T2 timeout, expected page not received.
Error type:
NON_RETRYABLE
.
1354 T.30 T1 timeout after EOM received. Error type.
NON_RETRYABLE
.
1370 Unspecified receive phase C error.
Error type:
NON_RETRYABLE
.
1371 Missing EOL after 5 seconds. Error type:
NON_RETRYABLE
.
1373 Receive buffer overflow.
Error type:
NON_RETRYABLE
.
1374 Bad CRC or frame (
ECM or BFT modes). Error type:
NON_RETRYABLE
.
1380 Unspecified receive phase D errors.
Error type:
NON_RETRYABLE
.
1381 Invalid response received in receive phase D.
Error type:
NON_RETRYABLE
.
1382 Invalid command received in receive phase D. Error type:
NON_RETRYABLE
.
1383 Unable to continue after PIN or PIP.
Error type:
NON_RETRYABLE
.
1583 Bad open ring 0 / kernel mode driver:
There is another instance of the
Class1 driver already loaded, or the Windows account attempting to load the
driver does not have Administrative permissions. Error type:
NON_RETRYABLE
.
1599 No modem response:
The modem did not respond to any commands.
Check cabling or if this is a PCI card modem, check that the card is properly
seated. Also try shutting the server down, leaving it off for 60 seconds, and
powering it back on. Error type:
NON_RETRYABLE
.
1600 Invalid response from modem:
The modem sent a response not al-
lowed by the Class 2 specification. Error type:
NON_RETRYABLE
.
1601 Not a Class 2 modem:
The modem does not support the Class 2 com-
mand set. Error type:
NON_RETRYABLE
.
1602 Send data was not supplied to the modem fast enough:
Check serial
port settings to ensure the fax server can send data fast enough to the modem.
Error type:
RETRYABLE
.
1607 Send collided with receive:
An outbound port was allocated just as the
port began to receive a call. Error type:
BUSY
.
1619 Timeout sending or receiving data from modem:
Either the driver
timed out on the modem during send or receive or a +FHNG code was greater
than 255. Error type:
NON_RETRYABLE
.
1620 Busy:
A busy tone was detected. Error type:
BUSY
.