FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 209)

4 – Appendices NET SatisFAXtion 8.7 Manual 209
allowed_send_transfer_types [string]: These settings control the type of fax
and file transfers that the driver can perform for a device. Format: Comma sep-
arated list of the following. Default:
FAX,ECM,V34 .
FAX
ECM
V34
dial_prefix [string(20)]: Data to be prepended to dial strings, typically 9, if
present.
4.2.1.2.1
Class1 Device
allowed_receive_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault:
45
.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default:
45
.
tapi_modem_name [string]: When specified, the driver will utilize TAPI so as
to not monopolize the usage of the serial port. This is the name of the modem
defined in the control panel modem applet. Format: Up to 128 characters.
tapi_modem_name_saved [string]: Copy of
tapi_modem_name .
fax_device_name [string]: Optional device name that will override the key
name that is used for the fax device name. Typically this is never used. Format:
Up to 32 characters.
csid [string(20)]: The CSI for receive and the TSI for send.
4.2.1.3
Class2 Global
cancel_receive_timeout_msecs [dword 0–65535]: If the modem has a large
buffer, there may be a long wait from the time of sending a
CAN
character (abort