FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual

Page 206

4 – Appendices

NET SatisFAXtion 8.7 Manual

206

send_image_modulation_timeout_msecs [dword 0–4294967295]: This is
how long to wait after sending a block of send image data to the modem before
assuming the modem is having problems. This number should be large enough
to account for the time done by the modem and serial driver buffering. Default:

200000

slow_at_pause_msecs [dword 0–65535]: This is how many msecs to pause
in the middle and at the end of the "

" for any command sent after a baud rate

change. This gives the modem time to auto baud and detect data/stop bit for-
mat before returning to its normal command interpreting state. Use this for old
modems. Default:

100

speaker_mode [string]: State of device’s speaker. This translates to an

ATM#

command. Default:

ON_UNTIL_CARRIER

speaker_volume [string]: Volume of device’s speaker. This translates to an

ATL#

command. Default:

LOW

stolen_port_restore_timeout_msecs [dword 0–65535]: This was used in
Win 16 and DOS, but probably does not have any application for when using
TAPI in Win 32 since the Unimodem driver is in control or modem reinit when
an app is done using a port. When not using TAPI in Win32, there is no way
that the port can be stolen in the first place. Default:

1000

allowed_receive_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of

14400

12000

9600

7200

4800

and

2400

. Default:

14400,12000,9600,7200,4800,2400

allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of

14400

12000

9600

7200

4800

and

2400

. Default:

14400,12000,9600,7200,4800,2400

carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault:

dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default:

flow_control [string]: Designates the type of flow control to use when send-
ing data. If the setting is

XON_XOFF

the driver observes

XOFF

signals when

sending. The driver uses no flow control when receiving. Format: Either

XON_XOFF

RTS_LEVEL

. Default:

RTS_LEVEL