FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual

Page 207

4 – Appendices

NET SatisFAXtion 8.7 Manual

207

rings_before_answer [dword 0–255]: Number of rings before modem ac-
cepts call. Default:

ser_device_name [string]: Win32 name for the serial port in the format of
COMXXX where XXX can be 001–999. This does not need to be specified if
the

tapi_modem_name

is specified. Format: Up to 6 characters.

init_string [string]: This is the basic modem initialization string. It should reset
the modem and init the required flow control. Format: Up to 80 characters.
Default:

&F&C1&D2V1E0S0=0S7=90^^

All modem commands start with AT, so this string does not need AT. The sym-
bols in the string mean the following:

2-second pause

Carriage return. There is a wait of

init_string_timeout_msecs

after carriage return to wait

to be returned.

Specifies a single

^^\

this is interpreted as

\^^

init_string_timeout_msecs [dword 0–65535]: How long to wait for re-
sponse after

in the

init_string

if there are no 2-second pauses before or

after the

. Default:

5000

close_string [string]: Determines what commands should be sent to a fax mo-
dem to restore it to its normal state of operation after the application has fin-
ished using it. See

init_string

description for string format explanation.

Default:

Z^^

io_buffer_size [dword 0–65535]: This is the size of the image buffer. The
necessary buffer size depends on host CPU speed and load as well as connect
speed. This buffer directly adds to driver page locked memory use so should be
as small as possible. However, too small a buffer will cause faxes to fail. De-
fault:

20480

show_console_scroll_back_buffer_size [dword 0–4294967295]: When
the debug output is

CONSOLE

, this is how big of a buffer to be used for scroll-

back. Default:

282144

show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for
the page locked debug buffer that ring0 code writes to and ring3 code extracts
from (on a thread) to the debugging output. This should be larger for when us-
ing serial capture mode since so much more data is written for debug. It should
probably be only about 1K for when using T.30 debug since the frequency and
amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default:

65536

debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the

debug_show_output

is set for

CON-

SOLE

and the

debug_show_file_path

is specified in the registry, then you can

get both

CONSOLE

and

FILE

debug output simultaneously. This is a device spe-